Product Info
Description
CARD,ARCNET
Repair
ICC’s large inventory investment includes DS200ACNAG1A. ICC’s highly skilled technicians have the training and expertise to repair DS200ACNAG1A. In addition, our DS200ACNAG1A repairs come with a warranty. Please fill out our Request a Quote form with DS200ACNAG1A in the Subject Line, and/or include DS200ACNAG1A in the Message, for additional information about ICC’s DS200ACNAG1A. A ICC Business Development Leader will assist you with your DS200ACNAG1A needs shortly!
Reman
Purchasing a remanufactured GE DS200ACNAG1A offers substantial savings over new/unused with the functionality and reliability to match. Our assurance in remanufactured products allows ICC to offer 24 Months Warranty.
Exchange
Exchange is the combination of quick supply with applied discount against your old faulty card. Send us your old GE DS200ACNAG1A and we will replace (exchange) with a remanufactured spare, supplied with 24 Months Warranty
DS200ACNAG1A is an ARCNET LAN Connections Board manufactured by General Electric as a part of the Mark V series used in gas turbine control systems. The ACNA terminal board serves as the connection for the ARCNET data link between the main controller, IOS, protection module, and mark V turbine control panel. Termination is made using a coaxial cable. Each ACNA can terminate two coaxial cables. Connector ARCPL is used only on the ARCNET model. The ARCNET Board is a simple PCB with two BNC connectors that are readily installed and removed on a Mark V or EX2000 drive system because it is located externally. Four metal film resistors (R1/R2/R3/R4), two transistors, one diode, and three capacitors (C1/C2/C3) are among the components. Two apertures rimmed with metal cut into either side of the card make up the board. GND1 and GND2 are the designations for these. Two communications relay devices are located in the center of the board. Relay schematics are printed on the upper surface of both components.
A single six-pin male vertical pin terminal connector is located along the centerline of the board, and two female BNC plugs complete the ARCNET Connection Card. These plugs are intended to make LAN communication easier.
TXA(-) - Transmitting and receiving signals, Channel A
TXA(+) - Transmitting and receiving signals Channel A
TXB(-) - Transmitting and receiving signals Channel B
TXB(+) - Transmitting and receiving signals Channel B
P5 - Power +5 V DC
DCOM - Power Digital Common
TXB - Transmitting signal selected by JP15 as isolated DLAN Circuit or RS-422
TXA - Receiving signal selected by JP15 as isolated DLAN Circuit or RS-422
