Product Info
Description
CARD-EX2100 MAIN I/O
Repair
ICC’s large inventory investment includes IS200EMIOH1A. ICC’s highly skilled technicians have the training and expertise to repair IS200EMIOH1A. In addition, our IS200EMIOH1A repairs come with a warranty. Please fill out our Request a Quote form with IS200EMIOH1A in the Subject Line, and/or include IS200EMIOH1A in the Message, for additional information about ICC’s IS200EMIOH1A. A ICC Business Development Leader will assist you with your IS200EMIOH1A needs shortly!
Reman
Purchasing a remanufactured GE IS200EMIOH1A offers substantial savings over new/unused with the functionality and reliability to match. Our assurance in remanufactured products allows ICC to offer 24 Months Warranty.
Exchange
Exchange is the combination of quick supply with applied discount against your old faulty card. Send us your old GE IS200EMIOH1A and we will replace (exchange) with a remanufactured spare, supplied with 24 Months Warranty
IS200EMIOH1A is an Exciter Main I/O Board manufactured by General Electric under EX2100 Series. It is a single-slot, double-height VME style board that is installed in the control rack. The EPCT, ECTB, EACF, and EXTB terminal boards' I/O is handled by EMIO. PT and CT signals are included in the I/O. Contact inputs, output relay drivers, and pilot trip relay drives are all available. It also sends logic level gate pulse signals to the ESEL board, which sends them to EGPA in the power conversion cabinet via the backplane. EMIO manages inputs and outputs from a variety of I/O boards connected to the control rack.
Application Data
The Power LED is connected to the 5 V dc power supply, and the Status LED is connected to the FPGA's IMOK output. On the board, there are no jumpers, fuses, or cable connectors. All I/O board cabling is connected to the control backplane (EBKP). Connector P1 communicates with the other control boards via the backplane, while P2 interfaces with the I/O signals via cable connectors located on the lower part of EBKP.
IS200EMIOH1A Board Replacement (Offline)
Ensure that the exciter has been deactivated.
Open the control cabinet door and check any electrical circuits for power before touching them.
Remove the EMIO board from the control rack with care as follows:
Loosen the screws near the ejector tabs at the top and bottom of the faceplate. (The screws in the faceplate are captive and should not be removed.)
Remove the module by lifting the ejector tabs.
Gently pull it from the rack with both hands.
Insert the replacement EMIO board into the appropriate rack slot.
Begin seating the board by firmly pressing the top and bottom of the faceplate with your thumbs at the same time.
Tighten the screws at the top and bottom of the faceplate to finish seating the board in the slot. To ensure that the module is seated squarely, tighten the screws evenly.
