Product Info
Description
TERM. BOARD, ANALOG INPUT(*2)
Repair
ICC’s large inventory investment includes IS200TBAIS1C. ICC’s highly skilled technicians have the training and expertise to repair IS200TBAIS1C. In addition, our IS200TBAIS1C repairs come with a warranty. Please fill out our Request a Quote form with IS200TBAIS1C in the Subject Line, and/or include IS200TBAIS1C in the Message, for additional information about ICC’s IS200TBAIS1C. A ICC Business Development Leader will assist you with your IS200TBAIS1C needs shortly!
Reman
Purchasing a remanufactured GE IS200TBAIS1C offers substantial savings over new/unused with the functionality and reliability to match. Our assurance in remanufactured products allows ICC to offer 24 Months Warranty.
Exchange
Exchange is the combination of quick supply with applied discount against your old faulty card. Send us your old GE IS200TBAIS1C and we will replace (exchange) with a remanufactured spare, supplied with 24 Months Warranty
IS200TBAIS1C is a safety-certified Analog Input/Output terminal board. TBAI consists of 3 DC-37 pin connections for connecting to the I/O processors. A single connector is used to accommodate simplex applications (JR1). All three connectors are compatible with TMR applications. The input signals for the R, S, and T controls are fanned to the three connections in TMR applications.
TMR outputs aggregate the currents of the three connected output drivers and use a measuring shunt to calculate the overall current. The total current signal is then presented to the I/O processors for regulation to the requested setpoint.
TBAIS1C is a safety-certified product. In the Mark VIeS SIS, YAIC does not support the 200 mA output option. TMR applications can use the same terminal board.
IS200TBAIS1C Installation
The following analog I/O types can be accommodated by TBAI:
Analog input, two-wire transmitter;
Analog input, three-wire transmitter;
Analog input, four-wire transmitter;
5 V, 10 V dc analog input
0-20 mA analog output
0-200 mA analog output
IS200TBAIS1C Operation
Each 24 V dc power output is rated for continuous output of 21 mA and is safeguarded against short circuit operation. The control system's 24 V dc supply can power the transmitters/transducers, or they can be powered separately. The JO jumper determines the current output type. Each output is monitored by diagnostics, and if a fault cannot be cleared by a command from the processor, a suicide relay in the I/O controller disconnects the relevant output.
Physical Characteristics
Fault detection
Monitor total output current. Check for hardware incompatibility using the connection ID chip.
Temperature range
-30°C to 65°C
Dimensions
10.16 cm wide by 33.02 cm tall
Diagnostics
The I/O controller interrogates each cable connector on the terminal board for its individual ID device.
The ID device is a read-only chip coded with the terminal board serial number, board type, revision number, and the JR, JS, JT connection location.
A hardware incompatibility fault is issued when the I/O controller reads this chip and finds a mismatch.
Configuration
The following are the options for jumpers:
Jumpers J1A through J8A allow you to choose between current and voltage input.
Jumpers J1B to J8B determine whether the return is linked to common or not.
Choose between 1 mA and 20 mA input current using jumpers J9A and J10A.
